Mini-Bolt LED Turn Signals
Hunting for a discrete LED turn signal upgrade for your motorcycle? These Mini-Bolt LED Turn Signals are just what you need. Small (the housing measures under 3/4″ across), and astoundingly bright, these LED indicators are terrific for mounting front or rear on your bike. These indicators are virtually hidden, until they light up. The Billet Bolt-In LED Turn Signals come with a wire installed and nut on the rear of the housing, making them very simple to install. Thanks to this simple installation procedure, the indicators are mountable just about anywhere on your bike. You just have to determine where to mount them and fabricate an appropriate bracket or bolt them into an existing bolt hole.
As these lights are directional, we recommend installation facing directly forward or behind of your bike. This provides the most effective light to ensure you are seen by other drivers on the road. The built-in wire on these turn signals is 30″ long (76.2 cm), allowing you to run wiring the necessary distance for a sleek, unobtrusive install. The lights are amber in color. If needed an LED flasher relay will help with the LED flash rate. We like the one found here.
SOLD AS A PAIR (2 LEDs in the package)
FEATURES
- 10mm x 1.0 bolt
- 30″ (76.2 cm) wire, plenty of length to allow for a clean installation, hidden and discrete
- Black housing with amber LED lighting elements
These lights are great, super bright and discreet. I drilled out the top two holes on my license plate and bolted these up. You don’t even notice them until they turn on. I did have one of the clear lenses fall off of one but the light still worked fine and I had been running it for a while. If they have figured out a better way to secure the lenses you can’t beat these.
Send us an email to [email protected] with the order number and a picture of the lens issue and we can send you a replacement.
Are these running lights and turnsignals or just turnsignals?
THANK YOU,
JOEY
They are amber and we only recommend them for turn signal only.
I made mounts for these as turn signals. My first set stopped working due to moisture getting to the chip. I’m ordering another set and will seal these up so no moisture can get in. Also, be careful as not to overtighten the nuts as the threaded post is just pressed into the lens. I highly suggest epoxy the post to the lens so it will not pull out due to the press fit which is very weak.
Thanks for advice. As mentioned we do not recommend these for car use. Motorcycles Signals see way less wear and tear than on a car.
Hi, I purchased these bug turn signals. Can it be wired direct? Or do I need a resistor or anything in between 12V battery to led? Thanks.